SME I01

DETAILS

Electrode for tough and wear-resistant against friction

Features/Characteristics

SME 101 is a electrode suitable for cutting all conducting metals. It produce smooth cuts and pierce metals in all positions Suitable for all positions.

These electrodes are good for preparation prior to repair of cast iron.

A forceful arc renders it possible to cut all metals and alloys without the necessity of supplementary gas, compressed air or oxygen or special torches.

This gives convenient, cost effective cutting method.

SME I01 Cutting Rod Uses/Applications

1. Suitable for cutting and piercing carbon steels, low alloy steels, stainless steels, Cast irons, copper alloys, aluminium and Nickel and Nickel alloys.
2. This is good for burning rivets dismantling work at site and for cutting off unwanted metal in foundry castings.
3. Suitable for cutting where gas cutting is not convenient

Note to usage

1. Clean the area by wire brush .Remove cracked metal
2. Preheat at 150°C if parts around 40°C or thicker than 25 mm
3. Use short are and lay stringer beads
4. Excessive weaving is not recommended as wide beads can cause excessive base metal overheating and degrade the weld deposit wear properties.
5. Follow the recommended welding parameters to achieve good deposit.
6. After welding allow parts to slow cool in still air

Disclaimers

Service Information

Documentation

• Safety Data Sheet
• Certificates of Conformance

More Cutting and Gouging Electrodes